AWWA LICENSE
CALIFORNIA CONTRACTORS LICENSE
CROSS CONNECTION CONTROL SPECIALISTS
Test - Repair- Installation- Cross Connection Control
No job too big or too small (1/2"-10") our AWWA certified backflow specialists work with you to facilitate the necessary requirements for approved backflow testing, repairs or installation.
BACKFLOW TESTING: Required by the State of California and your local Water District. Backflow testing is done annually to insure continued safety to the public water supply. If your backflow device is functioning properly and passes testing, the requirements for this year will be complete. If it fails it must be repaired or, if necessary, replaced.
BACKFLOW REPAIRS: Backflow devices have internal parts that open and close, which allows the flow of water. Over time, and depending on the usage of the valve, parts can become worn or damaged. This causes the valve to fail, when tested. The installation of new internal rubber parts in your backflow device will typically correct the problem. Once the repair is complete the valve is tested and certified.
BACKFLOW REPLACEMENT: Rust and corrosion along with worn out or non replaceable parts dictate when replacement of a backflow device is necessary. Typically a backflow device will need to be replaced every 10-12 years. At this time all new regulations and compliance requirements must be met.
NEW BACKFLOW INSTALLATIONS: Surveys are performed by your local water district. If a backflow is required they will notify you. The size of the required backflow is determined by the size of the water meter (ie. a 2" water meter requires a 2" backflow, a 6" water meter requires a 6" backflow, etc.). The location of the device is also determined by the water company. City codes and ordinances vary but it is most commonlt, the backflow device must be located on your property and not within the Public Right of Way. The standards imply that the backflow installation be within 18" of the back of the water meter or the back of the sidewalk. This is to avoid cross connections, which would leave the public water supply unprotected. CA. Assembly Bill 1953 ( effective 1-10-2010) requires that all domestic water backflow be lead free. All major manufactures Wilkins, Febco, Watts, Ames and Flo-Matic have lead free valve that are USC approved for installation. We will make the correct recommendations for your specific job.
PARTS, BACKFLOW VALVES AND EQUIPMENT: Bay Area Backflow service vehicles are fully stocked with Febco, Watts, Ames and Wilkins rubber parts kits. We also have 3/4"-2" backflow valves, should they be needed. This allows us to make necessary backflow repairs at the initial service, providing convenience along with saving you money and time. For backflow installations on larger jobs, 3" -10" our truck is equipped with a crane that will lift up to 6000 lbs. This allows us to safely and professionally replace large backflow's with less down time to your water supply.
CROSS CONNECTION CONTROL SURVEYS: Please see our seperate web page for survey information.
408-377-1807 (South Bay ) FAX: 408-683-0375
510-742-2272 (East Bay) 510-952-4444
650-212-2435 (Penninsula) 650-403-0907
925-829-3183 (Tri-Valley) 925-556-1406
800-400-1008 (CA only)
PHONE :
TOLL FREE:
TO SCHEDULE BACKFLOW INSTALLATIONS, TESTING OR REPAIR SERVICE:
Fax or email bayareabackflow@sbcglobal.net a copy of your notification from the water company, please include a cover sheet with your contact information. We will provide a written estimate for the necessary work. Once approved, you will be contacted and a scheduled appointment made to complete the work. During the repairs water does have to be temporarily interrupted. Your estimate will indicate the approximate time without water. If special circumstance prohibits work during normal business hours (M-F 7:30am - 4:30pm) please indicate the necessary scheduling in your correspondence.
EMERGENCY SERVICE: If your backflow is leaking, a car runs over it or it is stolen and you have little or no water to your commercial building, apartment complex or HOA, we can help. Our 24/7 emergency service is available. Our vans are stocked with parts and we are ready to take care of your service needs. Contact us at 800-400-1008 or 408-377-1807.
800-400-1008 (Ca. Only)
Copyright 2009 Bay Area Backflow Inc: Backflow installation. All rights reserved.
Backflow testing ensures your system is working properly.
